Product Description:
A flexible high water-resistant butyl rubber adhesive coated on a polyethylene net to give it dimensional stability with a siliconised kraft paper release liner. Conforms to rough, textured surfaces and has a wide range of applications for joining, sealing waterproofing and vibration absorption.
Application:
- Sealing of battens, purlins & studs behind cladding where fixings occur
- In Façade applications behind purlins, façade clips & mounts
- Holding and sealing in the HVAC industry
- Mounting of light weight signage to textured surfaces e.g. rendered concrete
Technical Details:
Tape Thickness: | 1.00mm |
Tensile Strength | 27.0 N/cm |
Adhesion to Steel: 11.7 N/cm
|
|
Service Temperature: | -30ºC to 80ºC |
Application Temperature | 5° to 40°C |
Shelf Life | 12 Months |
Surface Preparation:
It is up to the users to check the compatibility with the surface in terms of adherence, chemical compatibility and staining over the range of the application temperatures. The surfaces must be clean, dry and free of dust. In the case of friable, porous or fragile surface, it is advisable to stabilise them with a liquid primer. When replacing a bituminous tape, clean the surface of all bitumen traces and degrease with a solvent. For an application between 0°C and +5°C, check beforehand the absence of frost or of condensation on the surface. In case of watertightness, it is advisable to make sure that there is no risk of water retention. Start peeling off the protective liner and apply the product. Remove the protective liner progressively when installing. Carry out a roll-pressing to avoid inclusion of air bubbles. Match contours of the surface when installing in order to avoid stress likely to peel the product. The recommended application pressure is between 5 g/cm² and 15 g/cm².